CISCO 2950 SWITCH VLAN PASSWORD
CISCO 2950 SWITCH VLAN MAC

Issue the show mac-address-table command to verify the device is in the table as a permanent entry.Ģ950sw2(config)# mac-address-table static 4444-4444-4444 vlan 1 int fa0/5

CISCO 2950 SWITCH VLAN MAC

On switch2, permanently assign a device with MAC address 4444-4444-4444 to port fa0/5.This shows which devices are attached to which switch ports. On switch2, issue the show mac-address-table command.On switch4, issue the show spantree command.On switch2, issue the show version command.

CISCO 2950 SWITCH VLAN PASSWORD

(the enable password should be encrypted when displaying the configuration file). Configure it with a hostname of 2950sw2 and an enable password of cisco HyperTerminal into Switch 2 (Catalyst 2950).On switch1, issue the show interfaces command.On switch1, issue the show interface vlan1 command to verify that the IP address, mask, and default gateway are correct.Reassign the switch a hostname of 2950sw1 and an enable pass of ‘cisco’ (unencrypted).Īssign the switch an IP address of 197.10.1.99 with a subnet mask of 255.255.255.0.Īssign the switch a default gateway of 197.10.1.1 (your router’s Ethernet address).Ģ950sw1(config-if)# ip address 197.10.1.99 255.255.255.0Ģ950sw1(config)# ip default-gateway 197.10.1.1 On 2950sw1, go into privileged mode and then into global configuration mode.On 2950sw1, erase the saved configuration and reload the switch.Display the saved configuration in NVRAMĢ950sw1# copy running-config startup-config On 2950sw1, type copy running-config startup-config to save the active configuration to NVRAM.On 2950sw1, type show running-config to see the active configuration.Then we will use exit or ctrl-z to get out of configuration mode. We will then assign Switch1 a host name of 2950sw1. On Switch1, we will go into privileged mode and then into global configuration mode.Type ? to see a list of privileged mode commands. Press the enter key to get into the user prompt mode. HyperTerminal into the switch you want to be Switch1.

In this lab, you will configure basic IOS commands on Switch1 and Switch2 which are Catalyst 2950 switches.You will then connect Switch 1 and 2 together via port FA0/12 on each. You will connectE0 on your Router to E0/1 on Switch1. Prerequisite Setup – You will configure an Ethernet router with an IP address of 197.10.1.1 255.255.255.0 to E0. As you progress through your CCNA exam studies, I am sure you will find that hands on experience you receive from such as lab will go a long way in helping you acheive your Cisco certification! So to assist you, below we provided one of our CCNA Labs, Cisco 2950 Switch VLAN & Trunking Lab. In preparation of your CCNA exam, we want to make sure we cover the various concepts that we could see on your Cisco CCNA exam.

Cisco 2950 switch vlan